Timex W260 Manuel d'utilisateur télécharger pdf (Page 36)

When your workout is complete, press (in Performance mode) or hold (in Multisport mode) q to stop the

chronograph.

View complete heart rate data in Review mode.

Care and Maintenance

Watch

INDIGLO

Night-light

Press the INDIGLO® button to activate the night light. This electroluminescent technology illuminates the

watch display at night and in low-light conditions.

Water Resistance

• The Global Trainer™ Bodylink® System Watch is Water Resistant to a depth of 50 meters and to a pressure

of 86 p.s.i. This is equivalent to 164 feet below sea level.

• Water resistance is only maintained while the lens, pushbuttons, and case are intact.

• Rinse the Global Trainer™ Bodylink® System Watch with fresh water after any exposure to salt water.

CAUTION: TO MAINTAIN WATER RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

Heart Rate Monitor

Heart Rate Monitor Strap Maintenance

After use, rinse the heart rate strap in fresh water to avoid buildup of materials that interfere with heart rate

measurement.

Transmitter Battery Life

The battery on the Digital 2.4 Heart Rate Sensor should last more than two years if the sensor is used an

average of one hour each day. More frequent or longer use will decrease the battery life. Replace the sensor

transmitter battery if either of these conditions arise:

• When the sensor is properly placed on your chest, the Global Trainer™ Bodylink® System Watch cannot

read heart rate data.

• Heart rate error messages (such as SEARCHING FOR HEART RATE . . . ) appear more frequently.

To Replace the Transmitter Battery

1. Use a coin to open the battery compartment cover on the back of the sensor.

2. Insert a new CR2032 battery (or equivalent) with the positive (+) facing you.

3. Use a toothpick or straightened paper clip to press the reset button next to the battery.

4. Reinstall the battery compartment cover.

To Test the Sensor After Battery Replacement

1. Move away from sources of radio or electromagnetic interference, such as other heart monitors or bike sen-

sors.

2. Wet the heart rate sensor pads.

3. Fasten the sensor ﬁrmly to your chest, just below your sternum.

Turn on the Global Trainer™ Bodylink® System Watch.

Make sure the Global Trainer™ Bodylink® System Watch is set to scan for a heart rate sensor. See Sensors on

page ?? for information about scanning for sensors.

If the heart rate sensor is functioning correctly, a solid heart icon appears in the status bar, and a ﬂashing

heart icon appears in the HR ﬁeld on the performance view screen.

If these icons do not appear:

• Open the battery compartment cover, press the reset switch, and test again.

-OR-

• Reinstall the battery, and test again.

-OR-

• Re-pair the Digital 2.4 Heart Rate Sensor to the Global Trainer™ Bodylink® System Watch.

1 2 ... 31 32 33 34 35 36 37 38

Commentaires sur ces manuels

Pas de commentaire

Timex W260 Manuel d'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Montres Timex W260